久久婷婷丁香五月色综合啪

Hello! Welcome to Hebei Zeqi instrument and Equipment Co., Ltd., we will serve you wholeheartedly!
Customized Hotline fifteen billion eight hundred and thirty-three million seven hundred and eighty-nine thousand and two
 Cement soft scouring instrument

Cement mortar vibrating table

Release time: October 23, 2016 popularity: two hundred and seventy-six

Zt-96 Cement mortar vibrating table It is composed of a program-controlled frame and a proximity switch. When working, the synchronous motor drives the cam to rotate, so that the vibrating parts rise and fall after rising to the fixed value, and the vibration causes the cement mortar to vibrate under the action of force. The instrument adopts the approach switch counting automatic control, and stops automatically after 60 times. It is convenient to use and accurate in counting.

Main technical parameters of cement mortar compaction table:

Amplitude: 15mm ± 3mm
Vibration frequency: 60 times / s1s
Total weight of table (including arm): 13.75kg ± 0.25kg
Power supply: 220 V
Volume: 104 × 300 × 460mm

Installation and commissioning of cement mortar compaction table:

The correct installation is very important to the production and test results of the test piece. Please follow the following steps when installing.

1. It is installed on the concrete base according to the national standard t1762.5/1999. The volume of concrete is about 0.25m3 and the weight is about 600kg. When it is necessary to prevent external vibration from affecting the vibration effect, a layer of natural rubber elastic cushion with thickness of about 5mm can be placed on the whole concrete base. And pay attention to the body should have good electrical safety grounding.

2. Fix the vibration table on the base with anchor screws and make it horizontal after installation. The height of the four corners of the vibration table can be corrected with a height ruler. The height of the four corners of the vibration table is within 1 mm, and the length direction is within 0.5 mm. A layer of fresh thick mortar is laid between the instrument base and the base to ensure their complete contact. At the same time, this method can also be used to adjust the level of the table and arm

3. After tightening the screw (1) and (5), it should pay attention to the phenomenon that the anchor (5) is not fixed, and then check whether there is sticking force when the screw is tightened.

4. The position of anchor bolt is shown in the diagram

 Cement mortar vibrating table

comment

publish

fifteen billion eight hundred and thirty-three million seven hundred and eighty-nine thousand and two